Description
- The orthosis is made from low density polyethylene.
- The inside and outside lining is made of velour covering, for an increased feeling of comfort and for preventing chafing.
- The fabric elements can be easily removed for washing, to ensure proper hygiene.
- The materials used in its manufacturing are enabling X-rays to be carried out.
- If necessary, the upper cervical element can be detached from the lower element and used separately, for lighter treatment.
- Colour: grey
- Measurements: neck circumference.
SIZES:
- S/1 for 30-35cm circumference
- M/2 for 35-40cm circumference
- L/3 for 40-45cm circumference
INSTRUCTIONS FOR USE
Choose the correct size and fit the orthosis on the patient.
Fit the upper part with the back piece overlapping the front piece, and then fasten with the Velcro.
The height of both the occipital and mandibular supports can be adjusted with the side buttons.
As a precaution, make sure that the orthosis does not compress the glottis and keeps the cervical spine in a neutral position (preventing spine hyper extension and flexion).
Then fit the lower element and adjust the height to adapt it to the physical characteristics of the patient; to do so, remove the velour covering and slide the front and back plates along the fastening rails. After adjusting the height of the orthosis, fasten the shoulder and side straps and firmly tighten to ensure proper immobilisation of the cervical spine. Finally, make sure that the user can swallow normally and that the mandibular support enables the patient to open his/her mouth (2-3 cm) without excessive difficulty. The orthosis is designed to be used equally by male and female patients.
